#Loopback interface cisco software#
#Loopback interface cisco mac#

A loopback interface can provide a stable interface on which you can assign a Layer 3 address such as an IP or IPX address.

#Loopback interface cisco software#

The ID is unique per virtual interface type to make the entire name string unique for example both a loopback 0 interface and a null 0 interface can exist, but two loopback 0 interfaces cannot exist in a single networking device.Р”В¬isco IOS software supports four types of virtual interfaces For example: loopbackР’В 0, tunnelР’В 1, and fastethernet 0/0.1. You identify an individual virtual interface using a numerical ID after the virtual interface name. Virtual interfaces exist only in software there are no physical elements. Physical interfaces have some form of physical element-for example, an RJ-45 male connector on an Ethernet cable. Virtual interfaces are network interfaces that are not associated with a physical interface. Loopback Interfaces Versus Loopback Mode.To configure virtual interfaces, you should understand the following concepts: Information About Configuring Virtual Interfaces Feature Information for Configuring Virtual Interfaces Prerequisites for Configuring Virtual InterfacesР”В«efore virtual interfaces can be used in your network, you must have some physical (hardware) interfaces configured and be able to communicate between the networking devices on which you wish to use virtual interfaces.Configuration Examples for Virtual Interfaces.Information About Configuring Virtual Interfaces.Prerequisites for Configuring Virtual Interfaces.To find information about feature support and configuration, use the 'Feature Information for Configuring Virtual Interfaces' section.

Your CiscoР’В IOS software release may not support all features. This module was first published on May 2, 2005, and last updated on May 2, 2005.Р”Р‡inding Feature Information in This Module

This module describes the four common types of virtual, or logical, interfaces that can be configured using Cisco IOS software: Virtual interfaces do not have a hardware component such as the RJ-45 female port on a 100BASE-T Fast Ethernet network interface card. Virtual interfaces are software-based interfaces that you create in the memory of the networking device using Cisco IOS commands. ICMP Unreachable Messages from Null InterfacesР”В¬onfiguration Examples for Virtual InterfacesР”В¬onfiguring a Loopback Interface: ExampleР”Р‡eature Information for Configuring Virtual Interfaces Prerequisites for Configuring Virtual Interfaces In order to remove the loopback interface, use the no interface loopback 1 in config mode.Configuring Virtual Interfaces Table Of Contents When you have a Layer 3 switch, like a Catalyst 4500,6500,3550 or 3750, to configure loopback interface from the config mode, complete these steps: The management vlan of the switch acts like the loopback interface since they are both logical interfaces. The Layer 2 switches like 3500xl or 2950, the loopback interface is not needed since these switches are not capable of routing between interfaces.

#Loopback interface cisco mac#

Loopback interfaces do not have internal VLAN IDs or MAC addresses. There is no limit on the number of loopback interfaces you can create. This is an issue in networks with multiple equal-cost paths because under normal circumstances the packets that are generated by a networking device use the IP address from the outbound interface as the source address for the packets and because in a network with two or more equal-cost paths from the networking device to the receiving host each packet might use a different outbound interface. This address can be configured as the source address when the networking device needs to send data for protocols such as NetFlow,OSPF or Cisco Discovery Protocol (CDP) to another device in your network and you want the receiving device to always see the same source IP address from the networking device. A loopback interface can provide a stable interface on which you can assign a Layer 3 address.